5/4/2023 0 Comments Synology drive web portal![]() ServerIP: Change this to the IP address of your NAS.ĩ.Generally, something in the 8000’s should be fine. This needs to be something that’s not used. WEB_PORT: The port you’d like to access the admin portal with.WEBPASSWORD: password that you’d like to access the admin portal with.When completed, you can Save and then select Next to proceed. We now need to configure the Advanced Settings. NOTE: If you intend on using Pi-hole for DHCP (most people won’t), you need to check Execute container using high privilege.Ĩ. Give your container a name, enable auto-restart, and then select Advanced Settings. Select Use the same network as Docker Host, then select Next.ħ. Double-click the Pi-hole image to launch the Docker configuration.Ħ. Double-click Pi-hole/Pi-hole (official Pi-hole docker image) to download it.Ĥ. Open Docker, navigate to the Registry and search for Pi-hole. For this reason, you will need to access Pi-hole using your Synology NAS’s IP address and a defined port.ģ. 1.1 Host Network Interface (Option 1) – How to Setup Pi-hole on a Synology NASĪs stated above, this option will use the host network interface. Create one folder named pihole and another folder named dnsmasq.d. Inside of that folder, we are going to create two subfolders. Inside of this folder, we are going to create a folder named pihole. By default, Docker will create a folder named docker after it’s finished installing. We need to create two folders that we will map our Docker image to. Install Docker from Synology’s Package Center.Ģ. ![]() The steps below on how to setup Pi-hole on a Synology NAS need to be performed for either install, so we will get these steps out of the way first.ġ. Conclusion – How to Setup Pi-hole on a Synology NASġ. 1.3 DNS Configuration – How to Setup Pi-hole on a Synology NAS.1.2 Macvlan Network Interface (Option 2) – How to Setup Pi-hole on a Synology NAS.1.1 Host Network Interface (Option 1) – How to Setup Pi-hole on a Synology NAS.
0 Comments
Leave a Reply. |